12. Purging
i
If an actuator is unavailable, you can use this function to permanently log the actuator off of
the DuoFern sun sensor. An unavailable actuator increases the energy consumption of the
DuoFern sun sensor unnecessarily and should be avoided.
1.
Note the status LED (1), which:
2.
◆ flashes red while ‚Purging" is active
◆ lights up green for two seconds once „Purging" is complete.
i
13. Apply the current sunshine position
This function can be used to force the actuators to apply the current position of the blinds as
the sunshine position.
1.
Move the blinds manually to the desired sunshine position.
2.
The DuoFern sun sensor then transmits a signal to every actuator registered.
3.
4.
Every actuator registered applies the current position of the blinds as the new
sunshine position.
NOTE
Read the operating instructions for the relevant actuators and check the actuator settings
for the „Runtime"
Press the Connect button (2) for 5 seconds.
Press the Disconnect button (3) quickly twice.
EN
25