Description Of Automated Solar Functions - RADEMACHER 3200 00 69 Bedienungsanleitung

6.1 Description of automated solar functions

i
The DuoFern sun sensor measures the current brightness. Light sensitivity can be adjusted
using the rotary controller (6).
High
light sensitivity
NOTE
Adjust the brightness to the level at which the blinds should be closed.
Note the status LED (1), which lights up as follows:
◆ 2 x green, if the current brightness is greater than the light sensitivity set.
◆ 2 x red, if the current brightness is less than the light sensitivity set.
◆ no lights, if the current brightness is outside the measuring range of the DuoFern sun
sensor.
The automated solar functions are activated ...:
◆ if the current brightness goes over the brightness set for 10 minutes. A switching
command is then sent to the actuators registered.
The automated solar functions are stopped ...:
◆ if the current brightness goes below the brightness set for 20 minutes. A signal is
also sent to the actuators registered.
◆ if the DuoFern sun sensor's energy store is empty.
Please read the operating instructions for the relevant actuator in order to adjust all relevant
actuator-specific settings on the automated solar functions. Some settings may need to be
changed on the actuator to implement the sunshine position correctly.
Check the following settings in the relevant actuator.
◆ Runtime
◆ Sunshine position
Low
light sensitivity
EN
21