Logging The Duofern Sun Sensor Out; Starting A Connection Test (Test Ping) - RADEMACHER 3200 00 69 Bedienungsanleitung

10. Logging the DuoFern sun sensor out

i
1.
2.
The DuoFern sun sensor now transmits a logout signal. Logout mode remains active for
3.
10 seconds.
If the logout process is successful, the status LED (1) lights up green for two seconds.
4.
5. Log the next DuoFern actuator out by repeating 1 to 2, or exit logout mode.
NOTE
The status LED (1) lights up red for two seconds if the logout process fails, for example if:
◆ an attempt is made to logout a DuoFern actuator that is not logged on.
◆ the logout period expired without an actuator being logged out.
◆ an error occurred.

11. Starting a connection test (test ping)

i
With this function you can test whether the actuators you want are within the radio range
of the DuoFern sun sensor.
1.
The DuoFern sun sensor now transmits a test signal to all the actuators registered.
2.
3. Each actuator has a specific reaction to confirm the test signal (please read the operating
instructions for the relevant actuator).
24
Switch the DuoFern actuator to logout mode
(please refer to the relevant operating instructions).
Press the Disconnect button (3) quickly once.
Press the Connect button (2) quickly twice.
EN