Use Of The Manual - HOTTO Quadro Montageanleitung Und Bedienungsanleitung

UK
Symbols
The following symbols are used in these instructions/appear on the device:
Complies with the basic safety standards set by European Directives.
Failure to observe the instructions identified by this symbol may endanger persons.
Failure to observe the instructions identified by this symbol may lead to damage to the device.
Indicates a voltage that is present.
Failure to observe the instructions identified by this symbol may lead to damage to the device.
Read the manual.
Faulty and/or electrical or electronic appliances that are to be disposed of must
be handed in at the relevant recycling centres set up for this purpose
Introduction
Congratulations on your Hotto!
Your Hotto product consists of a boiling water boiler and a 3-in-1 tap with boiling
water function. You must use the Hotto installation set to install the Hotto. In addition to
boiling water, the Hotto boiler also provides hot water. You can adjust the maximum hot
water temperature on the boiler. You can also set the Hotto boiler to 70°C, which means
that the water will be heated to a maximum of 70°C.
Safety comes first at Hotto. That is why both the tap and the boiler are provided with
child-safe features. However, during use you should always be aware of the general hazard
of boiling hot water.
In case of failures, please consult the troubleshooter in this manual. If, in
spite of this troubleshooter, you still need some extra help, please do not hesitate to
contact our service line. For this you can also visit our website: www.hotto.com.
1.

Use of the manual

These instructions contain important information about commissioning, operating the de-
vice and maintenance. To ensure your safety and that of others we suggest that you read
these installation and operating instructions before using the device for the first time.
Please keep the instructions and other documentation close to the device.
This device was manufactured in accordance with current standards and has been
tested by competent agencies. The technical characteristics of the product can be found
on the rating plate at the rear of the boiler.
The device should be installed by qualified persons. All repair and maintenance work on
the device, for example the removal of limestone and water scale deposits, may only be
carried out by duly authorised technical staff. The applicable regulations and regional
requirements must always be duly observed!
12