milerd DETOXER Bedienungsanleitung Seite 7

EN
2. MANUAL MODE
In manual mode, you can adjust the intensity and duration of exposure to active
oxygen and ultrasonic waves. To do this, in the corresponding menu item, you
should set the required values using the buttons and .
2.1. LAUNCHING
After setting the processing parameters, it is necessary to lower the device into
water with food, check the set values and press the START button. The indicator
will turn red, and the display will show the cleaning treatment being applied and
the remaining time. When finished, the indicator will turn green and the word
FINISH will appear on the display.
Attention! The water level in the container should not exceed the mark
MAX
as specified on the exterior of the device. Do not start the treatment process if
the device is not submerged in water!
6