Warranty - T.I.P. UV-C-PJ 11W Gebrauchsanweisung

2. Clean the Quartz glass (3) and housing (5) thoroughly with water and a soft cloth.
3. If needed, remove calcifications from the Quartz glass (3) with a suitable solvents. Rinse out thoroughly
before reassembling.
4. If quartz glass tube or O-rings are defective they must always be replaced.
Assemble everything in reverse order.
While inserting the quartz glass into the protective housing (5), make sure the recess and groove engage
exactly. Assure the O-Ring (4) is exactly inserted in the groove of the quartz glass. Where necessary, grease
O-rings (4) with Vaseline. For installation of the lamp socket, the micro switch of the lamp socket (Fig. III, A)
is correctly inserted in the groove of the previously mounted quartz glass (Fig. III B). Otherwise without
contact there is no function (see Fig. I).
Fig.I
Replacing the UVC tube:
1. Disconnect the UVC lamp from the mains power for the maintenance.
2. Screw the socket (1) from the housing of the lamp. Remove the UV-C-tube (2) and replace the old tube with a
new one.
Assemble all parts in reverse order and ensure the O-Ring is correctly inserted. Lubricate the O-Ring with
some vaseline.
Caution! Do not touch UVC tube (2) directly with your hand; put on cotton gloves!
Old UV-C tubes shall not get broken and must not be disposed in regular garbage bin. Contact your local
waste disposal company. Do not use an sharp edged tools. In case Quartz glass cylinder or O-ring are
defect, they should get replaced immediately.
Function check of UVC lamp
In case the UVC lamp does not shine, the micro switch might not be activated. The UVC lamp should get
completely reasembled.
1. Assemble UV-C tube (2) including Quartz glass (3) to lamp socket (1).
2. Make sure O Ring (4) is inserted
3. Pull the protective housing (5) over the UV-C tube and Quartz glass and connect to the socket. By doing
so the micro switch should get active automatically.
The UVC tube works properly if you see a bluish light at the end of the lamp socket (1).
Winter - maintenance
Protect your UVC tube from freezing!
•
Completely clean the UVC tube as specified in the instructions.
•
Store the UVC tube over winter in a frost-free location
•

7. Warranty

The present device was manufactured and inspected according to the latest methods. The seller warrants for
faultless material and workmanship in accordance with the legal regulations of the country in which the
device was purchased. The warranty period begins with the day of the purchase and is subject to the
provisions below:
Fig.II
4
Fig.III
11