T.I.P. UV-C-PJ 11W Gebrauchsanweisung Seite 11

Persons not conversant with the contents of these operating instructions must not use this
device.
This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
The appliance must be supplied through a residual current device (RCD) having a rated
residual operating current not exceeding 30mA.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
Notes and instructions with the following symbols require particular attention:
Danger of injury or material damage if this instruction is not complied with
Danger of electrical shock that can result in injury or material damage if this instruction is not complied with
In addition to the basic safety instructions, also comply with the following instructions to prevent accidents:
1. ATTENTION : Before performing any installation or maintenance tasks, disconnect the electrical devices
immersed in the pond from the power source by pulling the plug out of the socket outlet. Do not operate
the pump if there are people in the water. Switch off the main fuse of the main domestic power supply,
before unplugging the mains cable, if the connection plug or the main power outlet are wet. Never
transport or suspend the device by the mains cable.
2. Ensure that the voltage specified on the type plate of the device agrees with the mains voltage.
3. Prior to connecting the device to the mains supply, ensure that the mains cable and the device are not
damaged in any way.
4. The mains cable of the device must form a loop that points downward (DRIP LOOP) to prevent water
from running along the cable and into the socket outlet.
5. The device must have a residual current circuit breaker (RCCB) with a rated residual current of max. 30
mA connected on the line side. Consult a qualified electrician.
6. Do not bury the mains cable in the ground; follow the installation instructions specified in the applicable
local regulations. Consult a qualified electrician.
7. Prior to placing the device in service, ensure that the installation has been properly executed.
8. Install the filter at least 2 meters away from the edge of the pond; ensure that it is attached in such a
manner that it cannot accidentally fall into the water and that the installation area of the filter cannot be
flooded.
9. Do not use or store the device in areas where there is danger of freezing. In winter the device should be
removed, emptied and stored where it is protected against freezing.
10. Do not let the pump run dry (without water flow).
11. Do not use the device with corrosive liquids.
12. The temperature of the pumped liquid must not exceed 35°C (max.) and must not underrange 2°C
13. ATTENTION! Only use the UVC filter together with the safety transformer included in the scope of
delivery. If there is a defect, the complete UVC unit must be replaced.
14. ATTENTION: This device emits UVC radiation that can harm eyes and skin. Do not use the bulb outside
of the device
15. ATTENTION: NEVER LOOK DIRECTLY INTO THE UVC TUBE WHEN IT IS SWITCHED ON
16. ATTENTION: This device consists partially of glass! Handle with care!
17. The max. temperature of the pumped liquid must not exceed 35°C
18. Never connect the filter to the public water supply network.
19. The UV filter is not designed for immersion in water. If the device should accidentally fall into the water,
do not, under any circumstances, attempt to get it out of the water, until you have pulled the mains plug
out of the mains socket outlet. Also unplug the mains plug if you determine that the exterior of the device
is wet
20. To avoid an overheating of the lamp, please switch of the lamp if there is no direct water flow.
21. ATTENTION! Temporarily stop the operation of the UVC lamp, while treating the water or fish inside your
pond with additional care products.
2
9