Replacing Carbon Brushes - Ronix 7112 Bedienungsanleitung

REPLACING CARBON BRUSHES

1- Remove and check the carbon brushes regularly. Replace when the
tool occurs obvious sparks or wear down to the limit mark.
2- Both carbon brushes should be replaced at the same time. Use only
Ronix brushed provide.
3- Use a screwdriver to remove the brush holder caps. Take out the worn
carbon brushes, insert the new ones and secure the brush holder caps
CAUTION!
Be sure to reinstall the knob after inserting new carbon brush.
After replacing brushes, plug in the tool and break in brushes by running
tool with no load for about 10 minutes. Then check the tool while running,
when releasing the switch trigger. If the tool is not working well, ask your
local Ronix service center for repair.
To maintain product SAFETY and RELIABILITY, repairs, any other
maintenance or adjustment should be performed by Ronix Authorized
or Factory service centers, always using Ronix replacement parts.
|
2 1
User Manual