Ronix 7112 Bedienungsanleitung Seite 22

.
TRIMMER GUIDE
1- Trimming, curved cuts in veneers for furniture and the like can be
done easily with the trimmer guide. The guide roller rides the curve and
assures a fine cut.
2- Install the trimmer guide method please refer to the straight guide
installation procedure.
3- When cutting, move the tool with the guide roller riding the side of the
workpiece.
EFFECTIVE AND SAFE FOR CUTTING
CAUTION!
- Before operation, always make sure that the tool body automatically
rises to the upper limit and the bit does not protrude from the tool base
when the lock lever is loosened.
- Before operation, always make sure that the chip deflector is
installed properly.
1- Set the tool base on the workpiece to be cut without the bit making
any contact. Then turn the tool on and wait until the bit attains full speed.
Lower the tool body and move the tool forward over the workpiece
surface, keeping the tool base flush and advancing smoothly until the
cutting is complete.
2- When doing edge cutting, the workpiece surface should be on the left
side of the bit in the feed direction.
3- Moving the tool forward too fast may cause a poor quality of cut,
or damage to the bit or motor. Moving the tool forward too slowly may
burn and mar the cut. The proper feed rate will depend on the bit size,
the kind of workpiece and depth of cut. Before beginning the cut on
the actual workpiece, it is advisable to make a sample cut on a piece
of scrap lumber. This will show exactly how the cut will look as well as
enable you to check dimensions.
|
20
Electric Router1850W