Ronix 7112 Bedienungsanleitung Seite 20

SWITCH ACTION
CAUTION !
- Before plugging in the tool, always check to see that the tool is
switched off.
- Switch can be locked in "ON" position for ease of operator comfort
during extended use. Apply caution when locking tool in "ON" position
and maintain firm grasp on tool.
- Make sure that the shaft lock is released before the switch is turned on.
- Hold the tool firmly when turning off the tool, to overcome the reaction.
1- To start the tool, move the switch lever to the I (ON) position.
2- To stop the tool, move the switch lever to the O (OFF) position.
3- The tool speed can be changed by turning the speed adjusting dial to
a given number setting from 1 to 6. Higher speed is obtained when the
dial is turned in the direction of number 6. And lower speed is obtained
when it is turned in the direction of number 1.
HOW TO USE THE STRAIGHT GUIDE
1- Install the straight guide on the guide holder with the wing bolt. Insert
the guide holder into the holes in the tool base and tighten the wing bolt.
to adjust the distance between the bit and the straight guide, loosen
the wing bolt and turn the fine adjusting screw. At the desired distance,
tighten the wing bolt to secure the straight guide in place.
2- When cutting, move the tool with the straight guide flush with the side
of the workpiece.
|
18
Electric Router1850W