PNI AP800D Bedienungsanleitung Seite 12

We recommend installing the engine to the right of the gate (seen from the
inside):
Terminal 3 - connect the red wire to the motor
»
Terminal 4 - connect the yellow wire to the motor
»
Terminal 5 - connect the blue wire to the motor
»
Installing the engine to the left of the gate (seen from the inside):
Terminal 4 - connect the red wire to the motor
»
Terminal 5 - connect the blue wire to the motor
»
Terminal 3 - connect the yellow wire to the motor
»
Note: For mounting the motor on the right side of the gate (inside view),
when you change the black and the green wire, check if the motor closes
and stops normally. If not, change the position of jumper J1 in the opposite
direction. For example, if J1 is now on position 1 and 2, then change J1 to
position 2 and 3.
User manual 12