Use Of Control Panel; Overview Of Control Panel - Poolstar Poolex Sel-In Installation / Benutzerhandbuch

USE OF CONTROL PANEL

Overview of control panel

On/Off button:
Turns the chlorinator on or off.
On, the LED is green. When off, the LED is red.
Low salt indicator:
Let's you know if salt level is correct.
If the level is good, the LED is green. Otherwise the LED is red. In this case, do
a test and add or remove salt (see "Required salt levels", page 32).
2-digit display:
Visually displays different information:
•
•
•
The mode switch button
Allows, by successive supports, to change the mode of use by incrementing.
During chlorine production, the green LEDs
correspond to the mode selected.
Production in progress, shown here
in summer mode
The button for setting reverse polarity time
Cycles through presets with each press of the button (4h / 8h or 12h) allowing you
to adjust reverse polarity time depending on water hardness. As water hardness
increases, the time should decrease (400 ppm => 4h and 10 ppm =>12h).
Chlorinator status: OFF when switched off
When the chlorinator is on, displays the water temperature by default to
make adjustment easier
Mode selected, changes with each press of the mode switch button:
CO: Covered Pool mode
P4: Spring mode
P6: Summer mode
On/Off button
2-digit display
Mode selector button
Button for setting reverse polarity time
Low salt indicator
Operating mode indicator
P8: Comfort mode
B1: BOOST 1 mode
B2: BOOST 2 mode
When the daily production is finished or in
case of shutdown, the 25% LED is red.
Power status indicator
35