SwitchBot Blind Tilt Benutzerhandbuch Seite 13

4. Check if your blind wand is perpendicular to the ground. If not, pinch the spring tab
to slide the cord up and down to adjust the wand's tilt angle. Finally use the base
cover to cover the mounting base.
Mounting base on the right
1. Remove the cord holder from the Type-C port (turn 90° upwards from the bottom
to remove), then install it back on from the other side (turn 90° downwards from
the top to install back on). Now the Type-C port should be facing right.
Open
13
Close