SwitchBot Blind Tilt Benutzerhandbuch Seite 12

2. Twist the coupling against the wand and make sure there is no relative sliding
between the coupling and the adapter.
Note: If the coupling slides over the adapter when you twist it, use the measurement
paper tape to measure your blind wand again and replace with a more suitable adapter.
Install the main unit of your Blind Tilt onto the wand
Mounting base on the left:
1. Pinch the spring tab on the cord holder and slide the cord holder upwards to fit into
the mounting base.
2. Push the slide switch on the main unit upwards to open the case.
3. Align the gears on the coupling and inside the main unit, then close the main unit
case. (Slide the cord holder up or down to adjust the position of main unit if you
have difficulty aligning the gears.)
12