Installing The Flight Battery; Transmitter And Receiver Binding - Blade 120 Bedienungsanleitung

Installing the Flight Battery

A
1. Lower the throttle stick to the lowest position (A) and
center all trims.
2. Set the Flight Mode Switch to Stability Mode (FM0)
3. Power ON the transmitter (B).
4. Slide the fl ight battery fully into the mount of the heli-
copter frame (C).
5. Connect the power lead to the battery (D), noting the
correct polarity.
CAUTION: Connecting the battery to the control
board with reversed polarity will cause damage
to the control board, the battery or both. Damage caused
by incorrectly connecting the battery is not covered
under warranty.

Transmitter and Receiver Binding

Your RTF transmitter comes prebound to the model. If you need to re-bind, follow the directions below.
MLP6DSM Binding Procedure (RTF)
1. Disconnect the fl ight battery from the helicopter.
2. Center all trims on your transmitter.
3. Power off the transmitter and move the throttle stick to the down/off position.
4. Connect the fl ight battery in the helicopter. The Blue LED on the control board fl ashes after 5 seconds.
5. When the Blue LED light is fl ashing, push in and hold down the left stick* while powering on the transmitter (you will hear a 'click').
6. Release the left stick. The transmitter will beep and the power LED will blink.
7. The helicopter is bound when the LED on the control board is solid blue (not blinking).
8. Disconnect the fl ight battery and power the transmitter off.
* The trigger switch may also be used for the binding procedure.
If you encounter problems, obey binding instructions and refer to the troubleshooting guide for other instructions. If needed, contact
the appropriate Horizon Product Support offi ce. For a list of compatible DSM
EN
B
C
6. Place the helicopter on a fl at
surface and leave it still until
the red LED changes to blue and glows solid, indicating
initialization is complete.
If the LED on the control board fl ashes rapidly, proceed
to the Transmitter and Receiver Binding section to bind
the helicopter and transmitter.
NOTICE: Do not allow the helicopter to move until the
LED on the control board is solid blue.
If you experience issues during initialization, refer to the
Troubleshooting Guide at the back of the manual.
CAUTION: Always disconnect the Li-Po battery
from the aircraft when not fl ying to avoid over-
discharging the battery. Batteries discharged to a voltage
lower than the lowest approved voltage may become
damaged, resulting in loss of performance and potential
fi re when batteries are charged.
®
transmitters, please visit www.bindnfl y.com.
8
nd glows solid indicating