GET SX1 PRO Installationsanleitung Seite 3

7. If the bike does not start or the engine is irregular, be sure
that the SX1 Pro ECU chosen is compatible with your bike model
and year, verify that the ECU is connected properly, and always
perform a TPS calibration.
8. The GET ECU supports the connection of multiple devices, such
as SX1 CONNECT, SX1 CONTROLLER, LC-GPA, QUICKSHIFTER, GPA
SWITCH, SL-1 SMART LOGGER:
-to connect up to two devices, use the GL-264-AA harness (included
in the SX1 PRO kit).
-to connect up to four devices, use the GL-266-AA harness (sold
separately).
9. OEM handlebar commands for map change and launch
control will not work after installing GET SX1 Pro ECU. Please
only use GET SX1 CONTROLLER (included in the kit), GET SX1
GPA SWITCH or GET SX1 LC-GPA module (sold separately).
10. This ECU has been developed for bikes without power
restrictors. Remove them before installing GET ECU. This manual
contains some example of standard power restrictors: please
contact your bike dealer to get more details about your bike
power restrictors and where they are located.
B. SX1 PRO SPECIFIC INSTALLATION
SX1 PRO is a fully programmable plug&play ECU. SX1 PRO is
the best solution both for original and modified engines: it is
possible to adjust the calibration map through both WiGET App,
by using the SX1 CONNECT device, and/or MAYA software.
WiGET App
SX1 Pro comes with 2 maps developed by GET R&D
Department, which can be easily switched thanks to the
Map Switch included in the kit.
3
EN