Before First Use; Using The Appliance - Philips HD7753 Benutzerhandbuch

4 Before first use
4.1 Setting the clock
Put the mains plug in the wall socket.
1
• The start/standby button lights up.
Press the start/standby button (Fig. 2).
2
The display lights up and the appliance
•
beeps twice.
Note:
D
If you do not press any button within
5 minutes, the appliance goes into standby
mode. In this case, the display goes out
and only the start/standby button stays
on to indicate that the appliance is still
switched on. In standby mode, you
can press any button to reactivate the
appliance.
• On the display 12:00 flashes to indicate
that you have to set the clock time. (Fig. 3)
Press the HOUR button repeatedly to set the
3
hour (Fig. 4).
• The appliance beeps each time you press
the button.
Press the MINUTE button repeatedly to set
4
the minutes. (Fig. 5)
• The appliance beeps each time you press
the button.
The display shows the set clock time. The
5
coffeemaker is ready for use.
4.2 Flushing the appliance
You need to flush the coffeemaker once before
first use.
Open the water reservoir lid. Fill the water
1
reservoir with fresh cold water up to the
10-cup indication. (Fig. 6)
Note:
D
Do not put coffee beans or ground coffee in
the appliance.
Close the water reservoir lid.
2
Put the insulated jug in the appliance (Fig. 7).
3
Note:
D
Make sure the jug lid is on the jug and the
arrow on the lid points to the 'closed/brewing'
symbol (see chapter 'Using the appliance',
section 'Using coffee beans'). Also make sure
the jug is placed properly in the appliance. Its
spout has to face forward into the appliance.
If the lid is not on the jug or the jug is not
placed properly in the appliance, the drip
stop function is activated automatically (see
chapter 'Using the appliance', section 'Drip
stop function').
Press the start/standby button (Fig. 2).
4
• The appliance beeps and the display lights up.
Press the pre-ground coffee button to switch
5
off the grinder (Fig. 8).
• The pre-ground coffee button lights up.
Note:
D
When you switch off the grinder, the number
of cups and the strength setting are not
shown on the display.
Press the start/standby button to start the
6
brewing process (Fig. 9).
• The freshness indicator flashes rapidly on
the display until the brewing process is
finished.
• The coffeemaker produces 5 beeps when
the brewing process is finished.
Empty the jug.
7

5 Using the appliance

5.1 Filling the water reservoir
Open the water reservoir lid and fill the
1
water reservoir with the required amount of
cold water. (Fig. 6)
There are indications for 4 to 10 cups
(550ml to 1375ml) on the water level
window. You can use these indications to
determine how much water to put in the
water reservoir. Keep in mind that the amount
of brewed coffee will be slightly less, since
ground coffee absorbs water.
7