Assembly And Commissioning - Me VYSYS 1010 Montageanleitung

4 Assembly and Commissioning

ASSEMBLY
The camera has 3 holes on its base, which are
intended for fastening the camera. Locate a
suitable place for mounting the camera.
The cables should be routed so that they
1
are protected from manipulation, for
example in a cable duct.
If the camera is mounted and operated
2
outdoors, the two plug connectors may
only be located in a place protected
against moisture. If this is not observed,
corrosion of the plug connectors can occur!
If necessary, use a water-protected
junction box.
Use the base of the camera as a template
3
for marking the drill holes. (Use a drill suit-
able for the dowels to drill the holes. The
enclosed dowels require a 6 mm drill)
CONNECTION
• The camera has a connecting cable with two
plug connectors on the end.
•
The RJ45 connector can be used to configure the
camera via Ethernet cable and make it available
to the system.
30
ENGLISH
VYSYS 1010
WIRELESS LCD NVR COMBO
•
The round socket is used to connect the camera
to the external power supply (DC voltage,
12 V DC / 1A).
NOTE !
The camera will be damaged if the connection or
voltages are incorrect!
Loss of warranty/guarantee!
•
A suitable round connector is required for
connection:
External diameter 5.5 mm,
internal diameter 2.1 mm.
The external contact of the round connector
must have Minus/-, the inner contact Plus/+.
A suitable mains adapter is enclosed, + and -
are labelled correspondingly.
• If necessary, the camera must be aligned
correctly so that the desired vision frame can
be monitored. The IR-LEDs are activated
automatically during darkness. However, the
LEDs are not visible to the human eye.