Coolproducts Rennrad Bedienungsanleitung Seite 49

4 Tighten the two nuts and check that the spacing bet-
ween the front wheel and the fork is the sam e on both
sides. (Tightening torque 20 Nm)
Danger!
If the front wheel is not properly secured, your child
may fall and injure him/herself.
5.3 Handlebar and safety pad
To fit the handlebar:
1 Place the handlebar in the mounting.
2 Adjust the required handlebar height. Note the "min.
Insertion" marking on the tube. The minimum inser-
tion line must not be visible above the clamp.
3 Straighten the handlebar so that it is at a right angle to
the front wheel.
4 Tighten the Allen screw.
(Tightening torque 20–30 Nm)
50