Initial Operation And Security Advice - Phobya UC-1 Bedienungsanleitung

1.2.4

Initial operation and security advice

After successful installation integrate the waterblock into the cooling loop. Only fasten
the fittings hand-tight. Be careful to use the dedicated Input (IN) and Output (OUT)
correctly. Good cooling performance can only be ensured with the correct use. If you
require help with the installation please use our support on the Phobya homepage.
Take the watercooling loop into operation WITHOUT the PC being turned on. Test the
waterblocks for proper installation and seal. Leave the system operating for at least
12 hours without the PC being turned on. Only turn on the PC when leaks can be
ruled out. To achieve the best possible cooling performance the waterblock must be
supplied with a sufficient flow of coolant and the cooling radiator must be sufficiently
powerful. As a coolant only anticorrosive / water mixtures approved by Phobya may
be used.
NOTE: Disregard of this manual may lead to serious damages of the product and
hardware. In case of an unprofessional and/or faulty installation the warranty does
not apply!
We wish you a good time with your new Phobya product!
Security advice:
Not suitable for children under 6 years (contains swallowable small parts). Do not run any cooling
components, without ensuring that cooling liquid flows through the cooling system. Coolers
driven without cooling liquid can become very hot. Caution: Burn Hazard! Coolers that are not
flowed through by cooling liquid can destroy the computer hardware. When switching on the
hardware, always make sure that the pump takes up its function. Please note that in order to
tighten the connectors no tools such as screw wrenches, calipers or alike may be used. *
All plastic products or metal threaded connections, which are linked with plastic parts, are easily
overloaded with tools! Hereby occurred tears or other damages, as well as damages occurred by
withdrawing coolant are not under the warrantee!
Use only Connectors with a sealing ring! By using a sealing ring a firm tightening with the hand
is enough! Your instructions manual clearly refers to the use of tools in exceptional cases!
6