Mounting the CD-ROM Pack
1
Power off your computer
"Shutting Down")
Do not shut down using the suspend or hibernation mode.
CAUTION
In the suspend or hibernation mode, do not remove/change the multimedia pocket de-
vice. Removing the device in the suspend or hibernation mode may damage the device.
2
Removing the device (Floppy disk drive)
● ● ● ● ●
1
Turn your computer over and open the cover by
sliding the latch.
E
2
Slide the MP release button. The device will
eject slightly.
Remove the device by holding both sides of the
3
device.
CAUTION
Please handle the device as shown (hold-
ing both sides).
Otherwise, the device may be damaged.
Also, do not apply excessive downward
force on the device.
Installing the device (CD-ROM Pack)
● ● ● ● ●
Gently insert the device into the multimedia pocket
by pushing on both corners until it clicks into place.
CAUTION
Do not install the device
upside-down.
Upside (Label side)
NOTE
You may use the floppy disk drive as an external device connected through the paral-
lel port, by using an optional FDD cable (CF-VCF271).
6
(
"Operating Instructions" of the computer,
Cover
MP Release Button
3
Label side down
1
2