Maintenance And Service - AEG FL80 Bedienungsanleitung

8
Product Overview
1
5 4 3
6
7 8
1. Surface lamp 6. Magnet holder
2. Spotlight 7. 12 v vehicle charging
3. On / OFF switch cable
4. charge control lamp 8. 230 v charging unit
5. charging socket
Technical Data
230 v Input voltage:
charging unit 230 v Ac, 50 hz
Output voltage:
6 v Dc, 300 mA
12 v vehicle Input voltage:
charging cable 12 v Dc
Rechargeable 3.7 v, li-ion, 1300 mAh
battery
2
charging time Max. 7 hours
lighting duration 40 lED approx. 3 h
80 lED approx. 1.5 h
Dimensions approx. 28.5 (16.5) x 22 x 4 cm
Weight 500 g
Protection class IP 20 compliant with
DIn En 60529
USE
Charging
Before initial use, please charge the rechargeable bat-
tery for the surface lamp fully. now the surface lamp is
ready for use.
1. connect the charging cable to the surface lamp
charging socket.
2. connect the charging unit to the 230 v mains sup-
ply or the vehicle charging cable to a 12 v vehicle
charging socket.
Observe the lED charge control lamp:
In operation "Spotlight function":
▪
Red: The rechargeable battery status is critical.
charge as soon as possible.
In operation "Surface lamp function":
▪
Red: lED remains lit as a control function so that
the light is not unintentionally left on when
the unit is folded together.
When charging:
▪
Red: Battery is being charged
▪
Green: Battery is completely charged
Switching the surface lamp on and off
Please check the re every use for possible damage.
never use a damaged product.
By repeated pressing of the On/OFF switch, the
surface lamp can be set to perform the following func-
tions:
Spotlight (pocket torch), Surface light 40 lED, Surface
light 80 lED, Off.
notice:
When the charger cable is connected with the charg-
ing socket, the lamp will immediately be switched off.
Once the charging cable is removed, the lamp resumes
its last selected function (Spotlight, Surface light or
OFF).
Attachment options
The surface lamp can be attached to ferromagnetic
surfaces with the holding magnets. caution! All three
holding magnets must have simultaneous contact so
that the surface lamp is securely held and does not fall
down.
MAInTEnAncE AnD
SERvIcE
Care
▪
charge the battery every six months until the green
lED lights up, even if the surface lamp was not in
use.
▪
clean the product with a soft, dry cloth. Do not use
any form of abrasive cleaner or solvents to clean the
unit. never dip the surface lamp into liquids.
▪
Store the surface lamp in a clean, dry and dark
place. Do not expose the surface lamp to tempera-
tures of under -15 °c for longer periods of time.
caution! never use a damaged product (e.g.,
worn cable, cracked casing).
If the product is damaged and requires repair, or other
problems with the product arise, always consult the
staff at the place of purchase or other certified special-
ist personnel.
GB
Disposal
Do not dispose of packaging or the product
through your household waste! The product
and packaging are made from recyclable
materials (plastics, metals, paper).
If the product is no longer suitable for use dispose of it
in an environmentally friendly manner in accordance
with your local ordinances.
Warranty and Service
The general warranty terms apply to defects in manu-
facturing and material.
Please return the defective product to your retailer. To
process your claim efficiently you will also need:
▪
A copy of the receipt including date of purchase.
▪
Reason for return (description of defect).
9