Operating Conditions; Warranty; Operation Using The Front Panel Controls Of The Hm6050-2 - Hameg HM6050-2 Handbuch

Operating conditions

The permissible ambient temperature range for operation is +10°C
...+40°C. During storage and transportation the temperature may be in
the range of -40°C...+70°C. In case of condensation buildup during
transport or storage the instrument may not be set in operation before
two hours of acclimatization. The instrument is intended to be used in a
clean and dry environment. It may not be operated in a heavily dust laden,
moist or explosive atmosphere or aggressive chemical effects.
There are no limitations for the operating position. A sufficient free air
circulation (cooling by convection) has to be kept for the instrument.

Warranty

HAMEG warrants to its Customers that the products it manufactures and
sells will be free from defects in materials and workmaship for a period
of 2 years. This warranty shall not apply to any defect, failure or damage
caused by improper use or inadequate maintenance and care. HAMEG
shall not obliged to provide service under this warranty to repair damage
resulting from attempts by personnel other than HAMEG represantatives
to install, repair, service or modify these products. In order to obtain
service under this warranty, customers must contact and notify the
distributor who has sold the product. In the case of shipments by post,
rail or carrier it is recommended that the original packing is carefully
preserved. Transport damages and damage due to gross negligence are
not covered by the guarantee. In the case of a complaint, a label should
be attached to the housing of the instrument which describes briefly the
faults observed. If at the same time the name and telephone number
(dialing code and telephone or direct number or department designation)
is stated for possible queries, this helps towards speeding up the
processing of guarantee claims.

Operation using the front panel controls of the HM6050-2

(1) Artificial Hand
This feature simulates the influence of the human hand. When performing
EMC measurements for devices, which are held in hand during use (for
example: electrical drilling machines, hairdryer etc.) the Artificial Hand
simulates the influence of the human hand on the EMC behavior of the
equipment.
If the DUT has a plastic housing, a conductive film should be used to
cover the housing at the location, where it is held in hand. A test lead is
used to connect the film to banana jack 1. DUTs with a metal housing are
connected directly to banana jack 1, if they don't have a protective ground
connection according to Class 1.
24
Subject to change without notice