RCS PMX-614 Bedienungsanleitung Seite 12

stage-sound
200 W at 8 ohms. Load impedances less than 4 ohms will
not draw additional power and may cause the unit to go into
protect mode.
The function of these jacks depends upon the position of the
amp mode selector located on the front panel. They provide
either the signal from the left main bus (Stereo setting) or the
combined left and right main signal (L+R/Monitor setting).
DSP (DIGITAL SIGNAL PROCESSOR)
EFFECT CHART
01 Reverb Hall 2
02 Reverb Hall 2
03 Reverb Room
04 Reverb Room
05 Reverb Plate
06 Reverb Plate
07 Delay & Reverb
08 Delay & Reverb
09 Delay 50% F.B.
10 Delay 50% F.B.
11 Delay 50% F.B.
12 Delay 50% F.B.
13 Chorus & Reverb slow 4.0 sec.
14 Chorus & Reverb med 2.0 sec.
15 Flanger & Reverb slow 4.0 sec.
16 Flanger & Reverb med 2.0 sec.
12
14-/16-CHANNEL POwER mIxER
5.0 sec.
3.0 sec.
2.0 sec.
1.0 sec.
3.5 sec.
1.5 sec.
170 ms / 3 sec.
300 ms / 5 sec.
100 ms
200 ms
350 ms
500 ms
Buchse. Die Ausgänge stellen bei 4 Ohm 300 W, bei 8 Ohm
200 W Ausgangsleistung zur Verfügung. Eine Impedanzlast
von weniger als 4 Ohm bezieht keine zusätzliche Leistung
und kann dazu führen, dass das Gerät in den Schutzmodus
übergeht. Die Funktionsweise der Buchsen hängt von der
Stellung des Amp Mode Selectors an der Vorderseite des
Powered Mixers ab. Danach wird entweder das Signal des
linken Main-Busses (Stellung Stereo) oder das kombinierte
Signal vom linken und rechten Main-Bus (Stellung L+R/Mo-
nitor) bereitgestellt.
DSP (DIGITAL SIGNAL PROCESSOR)
EFFEKTLISTE
01 Reverb Hall 2
02 Reverb Hall 2
03 Reverb Room
04 Reverb Room
05 Reverb Plate
06 Reverb Plate
07 Delay & Reverb
08 Delay & Reverb
09 Delay 50% F.B.
10 Delay 50% F.B.
11 Delay 50% F.B.
12 Delay 50% F.B.
13 Chorus & Reverb slow 4,0 sec.
14 Chorus & Reverb med 2,0 sec.
15 Flanger & Reverb slow 4,0 sec.
16 Flanger & Reverb med 2,0 sec.
5,0 sec.
3,0 sec.
2,0 sec.
1,0 sec.
3,5 sec.
1,5 sec.
170 ms / 3 sec.
300 ms / 5 sec.
100 ms
200 ms
350 ms
500 ms