MTP-Racing SIXTY6 SIX008 Montageanleitung Seite 7

9. Disconnect rear harness from main harness.
10. Loosen the original licence plate holder from be-
low with 4 bolts and remove.
11. The rear light and indicators can be taken from the
original licence plate holder and mounted on a rear
conversion kit (e.g. part no.: SIX1010).
Alternatively, use the accessory indicator and tail
light.
12. Remove approx. 5 cm of the sheathing from the
rear light connector on the rear wiring harness.
Connect the black cable of the license plate light
with the brown cable using a current thief. Cut the
grey-red cable and connect it to the red cable of
the licence plate light with a soldering connector,
insulate the remaining cable end at the connector
with heat shrink tubing.
13. Screw the cover plate (e.g. from the rear conversi-
on kit part no.: SIX1010) from below with 4 M4x14
bolts to the original fixing points.
14. Connect rear harness to main harness.