MTP-Racing SIXTY6 SIX008 Montageanleitung Seite 6

2. Loosen and remove the original rear brake caliper
fixing screw.
3. Place the carrier plate at the bottom with M6x20
and at the top with M6x40 on the casing of the
angular gear and tighten with 9.5 NM.
Apply mediumstrength threadlocker to both bolts
beforehand.
4. Apply medium-strength threadlocker to the
M8x20 Allen screw and screw the intermediate
part to the bottom of the carrier plate with 12 NM.
5. Screw the M8x65 Allen screw to the brake calliper
with 24 NM.
6. Apply mediumstrength threadlocker to two
M6x20 screws and screw the extension arm
onto the preassembled licence plate holder
with 9,5 NM.
7. Unscrew and remove the seat.
8. Route the licence plate light cable along the brake
caliper, brake line, standard paralell brace and
frame rear towards the tail light below the pillion
seat.
Extend cable as required with 2-core cable and
solder connectors.
5.
4.