Operating Guidelines - Midea M6 Bedienungsanleitung

OPERATING GUIDELINES

„ Startup methods
1. When placing the machine into the charging dock for charging, then the machine will start automatically (re-
commended method);
2. Long press " " for 3 seconds, then the power indicator flashes, and the machine makes a chord sound. When
the power indicator is always on, the machine starts successfully.
„ Start the cleaning
1. When the machine is in standby, briefly press "
2. If mopping is required, confirm the mopping assembly has been installed properly.
„ Pause the cleaning
1. During the cleaning, briefly press "
standby status.
„ Return to charge
1. After completion of the cleaning, the machine will enter its return-to-charge status;
2. If return-to-charge is required during the cleaning, proceed as follows:
① When the machine is in standby, briefly press "
charge;
② During the cleaning, briefly press "
another 1 second, and the machine will start to return to charge;
3. The main unit may be unable to return to charge automatically in some special conditions (e.g. energy
depletion, machine getting stuck etc.), manually put the main unit back to the charging dock.
„ Troubleshooting
1. When the machine reports a fault, the return-to-charge indicator turns red, please briefly press "
second to eliminate the fault;
2. After the fault is eliminated, briefly press "
3. After completion of the cleaning, the machine will automatically return to charge. It is recommended that the
machine should be kept in the charging dock. (Remove the mopping plate after completion of the charging)
„ Shutdown
1. If the machine will not be used for a long time period and needs to be shut down, long press "
seconds, and the power indicator begins to flash;
2. The cleaner makes a chord sound, and when the power indicator turns of, the machine shuts down successfully;
3. The cleaner cannot shut down when put in the charging dock, and if shutdown is required,please remove the
machine from the charging dock.
1. The machine will not start to clean when the battery energy is too low, please charge it before starting to
clean;
2. During the cleaning, the machine will automatically return to charge when the battery energy is too low, and
then go back to its interruption point to resume after the machine is fully charged;
3. The machine will enter its sleep mode when it has been in standby for more than 10 minutes, and in the sleep
mode, pressing any key will wake up the machine;
4. During the charging, the power indicator flashes, and then it is always on after completion of the charging.
" for 1 second, and it will start to clean the whole room;
" for 1 second, and the machine will pause the cleaning and enter its
" for 1 second, and the machine will start to return to
" for 1 second, and the machine will pause the cleaning; press "
" for 1 second to enter the cleaning status;
Notes
" for
" for 1
" for 3
17