Troubleshooting - AEG HK604200IB Benutzerinformation

an acute angle and move the
blade on the surface .
– Remove after the appliance is
sufficiently cool: limescale rings ,
water rings, fat stains, shiny metal-
lic discolorations. Use a special

7. TROUBLESHOOTING

You cannot activate the
appliance or operate it.
The appliance deacti-
vates.
The residual heat indica-
tor does not come on.
The sensor fields be-
come hot.
comes on.
comes on
comes on
Problem
2.
3.
Possible cause
You touched 2 or more
sensor fields at the same
time.
There is water or fat
stains on the control
panel.
You put something on
the sensor field
The cooking zone is not
hot because it operated
only for a short time.
The cookware is too
large or you put it too
near to the controls.
The Automatic Switch
Off operates.
The Child Safety Device
or the Lock function op-
erates.
No cookware is on the
cooking zone.
The cookware is incor-
rect.
The diameter of the bot-
tom of the cookware is
too small for the cooking
zone.
cleaning agent for glass ceramic
or stainless steel.
Clean the appliance with a moist
cloth and some detergent.
At the end rub the appliance dry
with a clean cloth.
Remedy
Activate the appliance
again and set the heat
setting in less than 10
seconds.
Touch only one sensor
field.
Clean the control panel.
Remove the object from
the sensor field.
.
If the cooking zone oper-
ated sufficiently long to
be hot, speak to the
service centre.
Put large cookware on
the rear cooking zones if
necessary.
Deactivate the appliance
and activate it again.
Refer to the chapter
"Daily Use".
Put cookware on the
cooking zone.
Use the correct cook-
ware.
Move cookware to a
smaller cooking zone.
ENGLISH
11