Call Tones - MT Logic RC-3500A Bedienungsanleitung

HL_TT9310 MT-Logic.book Page 13 Tuesday, January 27, 2015 4:41 PM
Once there is a transmission on the channel, the CTCSS code (if used) will be detected and
displayed.
• If you press the PTT button while listening to a found CTCSS
code, the PMR will go back in stand-by mode on the channel with
the CTCSS code.
• If no CTCSS code is detected there is a chance that DCS is
selected by the user. In this case you can scan for the DCS code.
(section 12.10.3)
12.10.3 Scanning for a DCS code
Once there is a transmission on the channel, the DCS code (if used) will be detected and
displayed.
If you press the PTT button while listening to a found DCS code, the PMR
will go back in stand-by mode on the channel with the DCS code.

12.11 Call Tones

A call tone alerts others that you want to start talking.
12.11.1 Setting the Call Tone
The Twintalker 9310 has 10 call tones.
Twintalker 9310
• Press the -button six times: "SC" and "CTCSS 00"
flashes on the display for the selected radio channel.
• Press the -button or the
scan.
• Press the -button seven times: "SC" and "DCS 00"
flashes on the display for the selected radio channel.
• Press the -button or the
• Press the - button eight times, "CA" is displayed and
the current call tone is flashing.
• Press the - button or the
Call Tone.
• Press the PTT - button to confirm and return to stand-by
mode.
Twintalker 9310
-button to start the CTCSS
-button to start the DCS scan.
- button to change to another
13