Overview Of Minimum Intervals For Inspection And Maintenance; Maintenance - Weh TSA30-S1 H2 70 MPa Betriebsanleitung

AE Operating instructions
contamination, it may be necessary for the operator to set a suitable maintenance
schedule independently. If the filter requires inspection or maintenance, send the
TSA30-S1 H 70 MPa to WEH.
2
8�3

Overview of minimum intervals for inspection and maintenance

No� Inspection
1 Check exterior for damage and dirt
Check breakaway coupling and con-
2 nections for leakage (see chapter 9
on page 25)
Check eccentric actuator for
3 ease of movement and function
No�

Maintenance

Return to WEH for
4
in-factory maintenance
* whichever comes first
Note: Component arrangement see chapter 3. Product overview / product description
on page 11.
Î If your application requires it, set shorter intervals than those specified above.
A significant reduction in the minimum intervals is particularly necessary if there
are any irregularities during the inspections.
8�4 Maintenance
Please note: Subsequent mentions of descriptions and position numbers refer to
chapter 3. Product overview / product description on page 11.
Î If you detect any leaks or malfunction, replace the WEH
for maintenance. Stop using the WEH
The following maintenance step may be carried out by the operator:
Î
Check the WEH
movement, wear, contamination or damage.
Page 24
MD-10418-L51-R1.0.0-03
Product for leak tightness and correct functioning – ease of
®
Initial
(before com-
missioning for
the 1st time)
X
X
After 3 years or 12,000 cycles *
®
Product immediately.
®
Weekly Semi-annual
X
X
X
Product or send it to WEH
X