SOLIS ICE CUBE EXPRESS 8510 Kurzanleitung Seite 32

Ensure that the device is not tilted or only tilted very briefly
6
during this process. If the device is tilted for an longer
period, please let it stand in upright for 12 hours before
using it again.
6. Wipe the inside of the appliance with a clean, dry cloth to remove any water left.
Plug the drain plug
7.
q
The appliance is now ready for use.
At the start of ice production, the ice cubes might be small and irregular. However, after a short period,
ice cubes will be dispensed in uniform size.
I N S TA L L AT I O N
V
1. Place the appliance in an upright position on a clean, dry, stable, flat, and heat and moisture resistant
surface.
If the appliance has been tilted for storage or transportation,
6
please let it stand upright on its feet for 12 hours before
switching it on.
Plug the power cable
2.
6
indicator light
flashes green.
w
Remove the scoop
3.
9
Fill the water reservoir
4.
Never fill the water reservoir above the MAX indicator.
6
Never fill the appliance with liquids other than clear and
6
fresh tap water (without carbonation).
Place the collecting tray
5.
M A K I N G I C E C U B E S
V
1. Press the ice size select button
blinks.
If the ambient temperature is below 15°C, it is advised to only make small ice cubes. Above 30°C, only
4
large ice cubes should be made. In between, both sizes are possible.
Press the power button
2.
production, and the corresponding indicator light
R E M O V I N G I C E
V
The appliance automatically detects when the collecting tray is full. The ICE FULL indicator light lights up.
Always empty the ice cube tray when the indicator light lights up.
In front of the collecting tray is a sensor. If an ice piece remains at this location, the appliance stops,
4
and the ICE FULL indicator light lights up, even if the collecting tray may not be full. Remove the stuck
ice piece, and the machine will resume normal operation.
32
back into place.
into a power outlet. The appliance enters standby mode, and the LARGE
and collecting tray
from the appliance.
8
with clean, fresh water.
4
back into the appliance.
8
to select the desired ice size. The corresponding indicator light
e
on the control buttons 5. The appliance starts with the ice
u
lights up green.
w