2. Sicherheitshinweise
Die Leuchte ist bestim -
mungs gemäß in unbeschä-
digtem und einwandfreiem
Zustand zu betreiben!
Als Ersatz dürfen nur Origi-
nalteile von CEAG verwen-
det werden!
Bei Arbeiten an der Not-
leuchte ist erst die Anlage
zu blockieren, der Batterie-
kreis zu unterbrechen und
dann das Netz abzuschal-
ten! Bild 4 zeigt das
Hinweisschild auf der Not-
leuchte.
Vor der ersten Inbetrieb-
nahme muss die Leuchte
entsprechend den im Ab-
schnitt Installation ge-
nannten Anweisungen ge-
prüft werden!
Die Notleuchtenkenn zeich -
nung vornehmen: Strom-
kreis und Leuchtennummer
zuordnen und eintragen.
Die Protokollführung gemäß
der nationalen Vorschriften
ist durchzuführen (entfällt
bei automatischer Protokol-
lierung)!
Alle Fremdkörper müssen
vor der ersten Inbetrieb-
nahme aus dem Gerät
entfernt werden!
Beachten Sie bei allen
Ar beiten an dem Gerät die
nationalen Sicherheits- und
Unfallverhütungsvorschrif-
ten und die nachfolgenden
Sicherheitshinweise in der
Betriebsanleitung, die mit
einem
versehen
sind!
6
2. Safety Instructions
The device shall only be
used for its intended pur-
pose and in undamaged
and perfect condition!
Only genuine CEAG spare
parts may be used for re-
placement and repair!
When working on the emer-
gency luminaire first the
system must be blocked,
battery operation must be
interrupted and mains must
be cut off. Fig. 4 shows the
indication label on the
emergency luminaire.
Prior to its initial operation,
the luminaire will have to be
checked in accordance
with the instructions as per
section Installation!
Carry out the marking of the
emergency luminaire: As-
sign the circuit and the lumi-
naire No. and enter them.
Recording in the minutes
shall be performed in com-
pliance with the national re-
gulations (is deleted in case
of automatic recording).
Any foreign matter shall be
removed from the luminaire
prior to its initial operation!
While undertaking any
servicing on the luminaire,
the national safety rules
and regulations for pre-
vention of accidents shall
be observed as well as the
safety instructions included
in these operating instruc-
tions marked with a
Bild 4
Fig. 4