MOUNTING WITH THE WAL-03 BRACKET (LEN-20 ONLY)
1. Remove the two M6 oval-head screws that are located
underneath the connector panel.
2. Fix the WAL-3 to the wall using two screws and wall
plugs. For this, use the part containing the two slotted
holes at right angles.
3. Fix the bracket to the loudspeaker using the WAL-3's
mounting plate. Apply medium strength thread lock
fluid to all screws. Firmly tighten all screws using the
required torque.
4. Tighten the M8 nut (F) just as far as it is still possible to
turn and angle the loudspeaker. Set the required rota-
tion and inclination angles.
5. Once you are happy with the above angles, tighten the
M8 nut (F) using a torque of 18 Nm.
SEE FIGURE 8.
SEE FIGURE 9.
SETUP AND OPERATION | ENGLISH
Figure 8
Figure 9
20