Fohhn LEN–20 Bedienungsanleitung Seite 18

MOUNTING WITH WAL-1 BRACKETS
1. Remove the two oval-head screws from the top and
base of the loudspeaker.
SEE FIGURE 2.
2. Fix both WAL-1 brackets to the wall using two screws
and wall plugs in each case. The loudspeaker itself
serves as the best distance gauge.
When mounting the longer LEN-150 and LEN-220
loudspeakers models, it makes sense to fix the low-
er bracket first and determine the position of the top
bracket using the actual loudspeaker.
Allow play of ca. 2 mm between the loudspeaker
and the bracket.
3. It is advisable to affix the supplied rubber wash-
ers around the drill holes on the top and bot-
tom surfaces of the speaker. This will prevent
the powder coating from becoming scratched.
SEE FIGURE 3.
4. Slide the loudspeaker between the two brackets.
5. Screw the brackets to the loudspeaker using the sup-
plied M6x25 screws and washers. Do not tighten the
screws at this point.
Apply medium-strength thread lock fluid to both
screws beforehand.
6. Adjust the loudspeaker then firmly tighten both screws
according to the required torque.
SETUP AND OPERATION | ENGLISH
Figure 2
Figure 3
18