Unitec PREMIUM Originalbetriebsanleitung Seite 28

28
10923_Schlagschrauber_BA_141205.indd 28
• Select a suitable socket spanner. When attaching it make sure that the socket
spanner is firmly and securely seated on the socket spanner holder (5).
• Place the tool firmly on the tyre's fixing element to be worked on.
• To tighten (clockwise) push the rocker switch to the rotation to the right
position (F) (3). Before use, check that the direction of rotation is correct.
For safety reasons the torque is restricted to 100 Nm in rotation to
the right. Please tighten wheel bolts with a torque wrench and a
torque of about 120 Nm. We would like to point out that wheel bolts
must be tightened again after the vehicle has been driven about
50 km. Check that the wheel bolts are firmly seated.
• To loosen bolts (anticlockwise) push the rocker switch to the rotation to the
left position (R) (4). Before use, check that the direction of rotation is correct.
• Loosening wheel nuts/bolts may require several impacts.
• Release the rocker switch (3 or 4) to stop the tool.
• After you have finished working, pull the mains plug (2) out of the mains
socket.
Remarks:
• Strictly observe the manufacturer's instructions regarding the
torque to use. There are no general rules here for torque levels
for aluminium or steel rims.
• Please check the correct seating of the wheel nuts/bolts with a
torque wrench before the vehicle is driven off.
• Check the correct seating of wheel nuts/bolts with a torque
wrench after 30-50 km of driving.
05.12.14 11:04