Pekatherm 0120D R Benutzerhandbuch Seite 7

•
Do not hold the product by the power cord to move or carry it.
•
If the power cord is damaged, it must be replaced by the manufacturer, its
service agent, or similarly qualified personnel in order to avoid and any hazard.
•
Inspect the product frequently for signs of wear or damage. If these signs appear,
do not use the product, and take it to an authorized service centre.
•
This product has no parts intended to be repaired or replaced by the used. If any
part of the product fails, or the product does not perform properly, or there is
any other kind of anomaly, do not attempt to repair it and instead take the
product to an authorized service centre.
•
The product must be returned to the manufacturer or his authorized agent if the
fuse of control unit has raptured.
•
For any further information, please consult our customer serviced.
INSTALLATION INSTRUCTIONS FOR HEATING
OVERBLANKET
Lay the product directly on the bed aligning it with the feet edge (see fig. I).
The power cord will come out from the side, approximately at your shoulder level when
lying down normally.
Make sure the product has no folds or creases. Check whether the power cord reaches
the nearest mains socket. If necessary, you can turn the product so that the power cord
comes out at the feet side.
Do not fold the product under the mattress.
If possible, do not use the product on adjustable beds or on twin mattresses; if this is
the case, make sure the heating part and the power cord do not get nipped or damaged.
OPERATING INSTRUCTIONS
1) Plug the product into the mains socket, making sure your mains' specifications
correspond to those of the product stated on the label. First connect the power
cord to the product and then to the mains socket. Use only the control unit
originally provided with the product.
2) If everything is correct the control unit is then automatically set at the level 0
which indicates that the product is switched off. All LED indicators will go off.
3) Proceed to adjust the temperature among the four available settings by pushing
the button on the control unit. The LED indicator corresponding to the
temperature. Setting you have selected will remain lit. At this pint the product is
running normally. After a few minutes you will be able to perceive warmth.
4) To switch off the product proceed to push the button until all the LED indicators
are off (level 0). The heating element remains switched off in this position. To
turn the product on push the button. Remember to unplug the product from the
mains if you do not use it for a considerable period of time.
5) Unplug the product and let it cool down before folding it for storage.
7