Fassi PRO25F Bedienungsanleitung Seite 20

STEP 2:
Attach the right pedal (12) with the R mark to the right crank (1) and fasten it with an open-end wrench (26). Note:
Tighten it clockwise.
Install the left pedal (13) with the L mark on the left crank (1) and fasten it with an open-end wrench (26). Note: tighten
counterclockwise.
The adjustment knobs (14) are attached to the front and rear of the main housing (1) respectively. Note that they do not
need to be tightened at this time.
STEP 3
: Insert the saddle post (4) into the main body (1), pull out the adjustment knob (14), and the adjustment knob (14) is
automatically inserted into the corresponding hole of the saddle post (4).
In the same way, insert the pull rod (5) into the main body (1) and the 7-shaped knob (11) so that the adjusting knob (11) is
automatically inserted into the corresponding hole of the pull rod (5).
Note: Pull out the adjustment knob (14) to adjust the height of the saddle post (4), and the 7-shaped knob (11) can adjust the
height of the handle post (5). After adjustment, the adjustment knobs (14) and (11) must be tightened.
14
13
20
4
14
OPERATING INSTRUCTIONS
20#
12
20
5
11
1
19