MSA Ultima MOS-5 Bedienungsanleitung

Ultima MOS-5 H2S Smart Transmitter
Quick Start Guide
Warning!
The quick start guide does not replace the operating manual. It is imperative that the operating manual be
read and observed when using the device. In particular, the safety instructions, as well as the information
for the use and operation of the device, must be carefully read and observed.
The operating manual can also be provided as a hard copy upon request.
1)
Mount the Detector
Tools Required
- "5mm" Allen head wrench (included).
- Flat-head screwdriver maximum 5 mm (not included).
- Adjustable wrench for conduit or cable gland connections (not included).
2) Field Terminations
Alarm Relay Contacts
TB3 (De-Energized) (Energized)
1 N/C
2 COM
3 N/O
GB
Warn Relay Contacts
TB3 (De-Energized) (Energized)
N/O 4 N/C
COM 5 COM
N/C 6 N/O
Dimensions in mm
TB1 – Sensor connection
TB2 – Power and signal connection
TB3 – Relay connection
TB2 Terminal connection
1 - 4-20 mA
2 - Channel 1 Modbus -
3 - Channel 1 Modbus +
4 - Channel 2 Modbus -
5 - Channel 2 Modbus +
6 - Remote Calibration
7 - Relay Reset
8 - Ground
9 - +24 VDC Power
Fault Relay Contacts
TB3 (De-Energized) (Energized)
N/O 7
COM 8
N/C 9
N/C N/O
COM COM
N/O N/C
MANMOS5-QG/01