Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.1. Fitting your Quiet Knight to 4', 4'6" and 5' wide beds (1220 mm, 1375 mm and 1524 mm
wide beds) only:
Firstly, remove the four pin clips which secure the two chromium plated side extenders
on the top of the unit. Pull out to the extenders so that they are level with the edge of
the bed ensuring that you do not exceed the last punched hole on the Quiet Knight
frame. Refix the pin clips to secure ensuring that they pass completely through the
frame and extension bars.
2.2. Fitting to 2'6" and 3' beds, (724mm and 915mm beds) only. You do not need to adjust
the chromium plated extenders.
2.3. The extension bars to the rear of the Quiet Knight base are packed for transit. Pull out
the bars to the desired width and turn the tubes so that the triangular sections are
pointing downwards. Insert the two pin clips provided.
3.
Fitting the two sideways base straps:
Firstly take the small strap section (approximately 285 mm long) comprising buckle, strap and
plastic loop. Pass the first small strap through the triangular part of chromium extender piece
and pass the buckle back through the plastic loop, so as to tie the small strap to the triangular
extender piece.
Repeat the above operation but, pass the small strap through the elongated slot on the base
of the elevator.
Now, using the long straps, (locking buckle, long strap and small loop), repeat the first steps
but fitting the long strap to the opposite triangular part of the strap and to the opposite
integral slot. Pass the long straps traversley (side to side) under the bed base, bringing them
up to clip into the small straps. Tighten off by pulling the strap through the locking buckle.
Once tight, tie off for extra security.
4.
Fitting the length-way strap:
Firstly take the short strap and pass through the integral painted metal rectangular loop
located centrally at the rear of the unit, then pass the strap back through the plastic strap
loop to secure. Then, take the long strap and attach to the centre of the front of base frame,
repeating the action of the small strap.
Pass the fixed strap lengthways under the bed base, bringing it up to secure with the buckle
end secured to the rear of the elevator tighten off and knot off to secure.
Usage and Maintenance Instructions
4
Ver. 2 07/2012 (1005)
Werbung
