Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PLASMA E-TECHNOLOGY FILTER
Maintenance
Assuming the Plasma E-technology Filter is installed as directed, it requires little maintenance.
The Plasma Filter has cleaned automatically the moment it is in operation. Should the exterior
or sensor become soiled, it can be easily cleaned using a vacuum cleaner. No parts need to
be replaced periodically. You should always follow your hood's maintenance instructions. The
grease filters must be of good quality. These must also be cleaned regularly. This will prevent
contamination of the Plasma E-technology Filter.
Installation instructions
The Plasma Filter can be used on almost any existing exhaust unit and new extraction unit. You
need a power outlet within a suitable distance. (220 V and grounding not necessary).
In addition, the extraction unit must be suitable for recirculation (the shaft or room where the
filter is placed must have an opening through which the filtered air can be ventilated back).
We recommend that this opening not be placed towards the wall or ceiling or with a minimum
distance of 500 mm.
Attention
It is important that the filtered air only leaves the room where the filter is installed through
this opening/grid/reduced plinth and does not escape through cracks, other openings,
cabinets, or drawers. The principle of recirculation is then interrupted, the airflow is no
longer constant.
If you are placing the Plasma Filter in a room that is not completely airtight and where the
discharged air can leave not only through a grille/reduced baseboard, but also in other
ways, make sure that the filter is placed in a box or cove, and ducted to the opening/grid.
EN 8
Werbung
