Omnitronic KEY-288 Bedienungsanleitung Seite 15

• Toggle: Each time you press the key, a
control change message with the On value or
Off value will be transmitted alternately.
On Value
Specifies the On value of the control change or
note on message.
Off Value
Specifies the Off value of the control change
message.
Pads
Operating a trigger pad will transmit either a
note message or control change message,
depending on the assign type.
For each pad, you can specify the type of
operation, its note number or control change
number, and the values that will be transmitted
when the pad is pressed.
These MIDI messages are transmitted on the
global MIDI Channel.
Assign Type
This specifies the type of message that will be
assigned to the pad. You can disable the pad
(no assignment), or assign a note message or
a control change message.
Pad Behavior
Selects one of the following two modes:
• Momentary: The Note On or On Value will be
transmitted when you press the trigger pad,
and the Note Off or Off Value will be
transmitted when you release it.
• Toggle: The Note On or On Value will be
transmitted alternately with the Note Off or Off
Value each time you press the trigger pad.
CC/Note Number
Specifies the CC number or note number of the
control change message that will be
transmitted.
On Value
Specifies the On value of the control change or
note on message.
You can set this only if the assign type is
[Control Change].
Off Value
Specifies the Off value of the control change
message.
You can set this only if the assign type is
[Control Change].
Rotary controls [Knob 1 to 4]
Operating a rotary control will transmit a control
change message. You can enable/disable each
control, specify its control change number, and
specify the values transmitted when the control
is turned fully left or fully right.
Enable/Disable
Enables or disables the control. If you have
disabled a knob, turning it will not transmit a
MIDI message.
CC Number
Specifies the control change number of the
control change message that is transmitted.
Left Value
Specifies the value of the control change
message transmitted when you turn the control
all the way to the left.
Right Value
Specifies the value of the control change
message transmitted when you turn the control
all the way to the right.
Faders [Slider 1 to 4]
Operating a fader will transmit a control change
message. You can enable/disable each fader,
specify its control change number, and specify
the values transmitted when the fader is moved
fully upward or fully downward.
Enable/Disable
Enables or disables the fader. If you have
disabled a fader, moving it will not transmit a
MIDI message.
CC Number
Specifies the control change number of the
control change message that is transmitted.
Upper/Right Value
Specifies the value of the control change
message transmitted when you move the fader
all the way upward.
Lower/Left Value
Specifies the value of the control change
message transmitted when you move the fader
all the way downward.
15/16 00068822.DOC, Version 1.0