Powerfix Profi PDS 30 A1 Bedienungsanleitung Und Sicherheitshinweise Seite 16

Usage
♦ Loosen the locking screw
♦ If necessary, press the two locking bolts
pull the lower bar
is located under the load to be supported (Fig. C).
♦ Allow the two locking bolts
Use the red line which marks the position of the locking bolts
on the lower bar
♦ If the length of the lower bar
upwards (Fig. E) and pull the upper bar
♦ Re-tighten the locking screw
♦ To make fine adjustments to the height, press the pump lever
until the rubber pad
(Fig. G).
♦ To loosen and remove the prop, press the locking lever
upper bar
♦ Loosen the locking screw
♦ Hold the tube
out of their detent (Fig. B).
♦ Push the lower bar
A
C
PDS 30 A1
5
(Fig. A).
4 out up to the required height until the rubber pad
7 to engage completely in the tube
4
as an orientation aid.
4 is insufficient, push the locking lever
5 (Fig. F).
1
is located firmly under the load to be supported
2
has been completely retracted (Fig. H).
5 (Fig. A).
6 firmly with one hand and press the engaged locking bolts
4
back inside completely.
7 out of their detent (Fig. B) and
2 out to the required height.
3
8 upwards until the
B
D
GB │ IE
1
6 detent.
7 (Fig. D)
8
several times
7
│ 13 ■