Bestway 58665 Bedienungsanleitung Seite 2

TECHNICAL SAFETY INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS.
• To reduce the risk of injury, do not allow children to use, assemble or disassemble this product. Adults only.
• Do not remove or obstruct the float opening while the filter pump/sand filter is operating.
• Do not use the filter pump/sand filter while the pool is occupied.
• Ensure the filter pump/sand filter is unplugged before any maintenance begins to avoid risk of injury or death.
NOTE: Drawings are for illustration purposes only. May not reflect actual product. Not to scale.
Applicable Pump: 1,500-3,200 gal./h Filter Pump or Sand Filter
Applicable Pool: 22 ft. (6.7 m) or smaller Above Ground Pool
HOW TO USE THE PRODUCT
If the following situations occur during operation, to keep the robot in the best working condition, please refer to Section
1. During operation, if the hose sinks below the water surface, please adjust the position of the float.
2. When using with a high-flow pump, if the following situations occur (see below), please refer to the operation diagram and adjust the pressure
relief valve knob to appropriately reduce the running speed of the cleaner.
Situation 1: The hoses are straightened out at the beginning of use, but they become tangled during operation.
Situation 2: The robot is running so fast that the wheels tip over or do not touch to pool floor.
3. If the running track does not cover most of the pool area, or the running track is repeated, please adjust the wheel angle knob appropriately.
NOTE: When using with a 1500 gal. filter pump, please remove the brush as shown in Step 4 in Section
NOTE: It is normal for the robot to leak water at the water pipe joints during the water supply process.
STORAGE
• We strongly recommend disassembling the product during the off-season (winter months) and storing it in a dry place with a moderate
temperature between 10°C / 50ºF and 38°C / 100ºF.
TROUBLESHOOTING
Problem
Debris compartment is full.
Pressure relief valve filter is clogged.
Pool suction fitting is clogged.
The filter cartridge or the sand
is too dirty.
The robot does not
capture the debris,
or it moves slowly or
Air inside the pump.
does not move at all.
The robot is stuck on wrinkles.
Wheel is jammed.
The water valve did not open.
Damaged debris compartment
or pressure relief valve filter.
Hose not straightened out.
The hoses are entangled
The hose sinks into the water.
The robot running speed is too fast.
The driving path of the
The wheels are not in the correct
robot cannot cover the
position.
entire pool
OWNER'S MANUAL
Possible Cause
Clean the debris compartment as shown in Section
Clean the pressure relief valve filter. Rinse with water to remove debris.
Clean the debris compartment as shown in Section
Filter pump
- Clean the filter cartridge or replace if necessary.
Sand filter pump
- Disconnect the cleaner from the pool, perform backwash and
rinse to clean the sand.
Stop the filter pump or sand filter, purge the air and start again.
Check the bottom of the pool. If there are wrinkles, level the pool to reduce them.
Check to see if the debris screen inside of the head is dirty. Clean the debris
screen.
Check to see if the filter cartridge or filter sand is dirty. Clean the filter cartridge or
backwash the filter sand.
Check and remove debris from the wheel.
Open the water valve.
Return to the shop to get assistance.
Turn off the pump, reconnect the product at the diagonal position of the pool,
the water hose should be in a C shape, the product should be placed into
the water in the direction of the water hose.
Adjust the position of the float to make the hose float on the water.
Regulate the pressure relief valve.
Adjust the wheel driving angle.
2
.
.
Solution
.
.