Fronius DPS 2500 Bedienungsanleitung Seite 17

Mounting the arc
cut-off box (op-
tional)
Mount arc cut-off box
Connecting and Before putting the system into service:
checking the
1
protective con-
ductor
2
3
Check protective conductor connection of all power sources with the trolley
or the 19" rack for correctness.
Check whether the trolley is provided with a suitable protective conductor
connection (at least 6mm²).
Check protective conductor on the trolley or the 19" rack
At the rear side of the trolley there is a
rail for mounting an arc cut-off box.
Mounting angles are not included in
the scope of supply.
Mount mounting angles on arc cut-
1
off box
Hang arc cut-off box on mounting
2
rail and tighten screws
Connect arc cut-off box
3
Connect protective conductor
4
17