Fronius DPS 2500 Bedienungsanleitung Seite 15

Trolley assembly
General
Danger from work that is not carried out properly.
This can cause severe injury and damage.
▶
The assembly is explained by the example of the DPS 2500 trolley. The assembly
of the other versions is carried out accordingly.
Assembly of
DPS 2500 power
source
Power source assembly
Assembly of 19"
rack (optional)
Monut 19" rack
WARNING!
Only carry out the detailed work and installation after having completely
read and understood these operating instructions.
Check screwed connection of
1
mounting brackets and trolley for
tightness
Place power source onto mounting
2
brackets
IMPORTANT! The mounting bra-
ckets must be inside the plastic
feet of the power source.
Fix power source with mounting
3
brackets by means of enclo-
sed "Extrude-Tite" screws - two
screws each at the front and rear
side
Mount protective conductor con-
4
nection
Dismantle mounting brackets for
1
the DPS 2500 power source from
the trolley
Insert 19" rack into the trolley
2
Fix rack on the trolley by means of
3
the 4 enclosed M8 x 30 screws
Mount protective conductor termi-
4
nal block (not included in the
scope of supply) and connect pro-
tective conductor with rack.
15