Fronius DPS 2500 Bedienungsanleitung Seite 16

Mounting the
1
power sources in
2
19" rack (optio-
3
nal)
4
5
6
7
IMPORTANT! Only fix cover by means of the two Extrude-Tite screws. The casing
screws are a suitable protective conductor connection for grounding the cover.
The screws must not be replaced by other screws without reliable protective con-
ductor connection.
Mounting the ge-
nerator housing
(optional)
Fitting the 19" generator housing
Mounting the
traction release
(optional)
Mount traction release
16
Remove dummy cover
Insert power source in 19" rack and tighten screws
Thread power cable through traction release
Connect power cable with power source
Connect protective conductor with power source
Tighten traction release
Mount cover
Remove the DPS 2500 power
1
source fastening bracket from the
trolley
Insert the generator housing into
2
the 19" rack in the trolley
Fasten the generator housing to
3
the trolley with the 4 enclosed M8
x 30 screws
Fit the earthing terminal strip (not
4
supplied) and connect the earth
lead to the generator housing
At the rear side of the trolley there is a
rail for mounting the traction releases
for mains and power cables. The trac-
tion releases are not included in the
scope of supply.
Lay cable at the rear side of the
1
trolley
Hang traction release on the rail
2
and tighten screws