Aktiia Init I1 Bedienungsanleitung Seite 8

9 Power supply and charging
The battery of Aktiia Cuff is a built-in rechargeable li-polymer battery. The battery capacity is 1000 mAh. If charging for the first time (immediately after
purchase), after not having used it for a long time, or if the battery stops working while using the device - make sure to fully charge the Aktiia Cuff.
To charge your device :
1. Switch ON your Aktiia Cuff, the light indicator will flash blue.
2. Connect the USB microB connector of the provided USB cable to the device's connector port.
3. Connect the USB A connector of the USB cable to a power source with an output of 5V and 1A.
4. The light indicator will flash green to indicate charging and stay green when fully charged.
Charge the battery under following circumstances :
• When the red light is flashing, the battery power is low.
• When powering on the monitor, the light doesn't light up
Note : Charge at least once every three months. If the battery completely loses all charge, it may not be rechargeable anymore.
Batteries shall not be exposed to excessive heat such as direct sunshine, fire, or other similar situations. The battery could explode causing injury or death.
Do not attempt to replace the device battery: it is built-in and not changeable. Only charge the battery in accordance with the user instructions supplied with
the device. Do not use the blood pressure monitor while charging. Do not clean the blood pressure monitor when it is being charged.
7 – EN