Levenhuk LC900 Bedienungsanleitung Seite 5

Speed mode
In this mode, you can measure the speed of moving objects. Point the reticle at a moving target, and then press the Power/measure
button (1). Do not let the moving object out of your field of view in order to display the indication (Fig. 7).
Specifications
Measuring range
Units of measurement
Magnification
Objective lens diameter (aperture)
Laser class
Protection level
Power supply
Operating temperature range
Storage temperature range
The manufacturer reserves the right to make changes to the product range and specifications without prior notice.
Care and maintenance
This is a class I laser product. Please DO NOT look directly into the beam with unprotected eyes or through an optical device at any
time and never direct it toward other people. Do not remove any safety labels. Do not aim the device directly at the Sun. Do not try to
disassemble the device on your own for any reason. For repairs and cleaning of any kind, please contact your local specialized service
center. Protect the device from sudden impact and excessive mechanical force. Do not use the product in explosive environment or
close to flammable materials. Store the device in a dry cool place. Only use accessories and spare parts for this device that comply
with the technical specifications. Never attempt to operate a damaged device or a device with damaged electrical parts! If a part
of the device or battery is swallowed, seek medical attention immediately. Do not scratch or touch the optical surfaces with your
fingers. Use only dry, lint-free cloths to wipe the outer parts of the device. Do not use cleaning fluid to avoid the electronics damage.
To avoid scratching the lenses, only use a soft cloth and do not press too hard.
Battery safety instructions
Always purchase the correct size and grade of battery most suitable for the intended use. Always replace the whole set of batteries
at one time; taking care not to mix old and new ones, or batteries of different types. Clean the battery contacts and also those of the
device prior to battery installation. Make sure the batteries are installed correctly with regard to polarity (+ and –). Remove batteries
from equipment that is not to be used for an extended period of time. Remove used batteries promptly. Never short-circuit batteries
as this may lead to high temperatures, leakage, or explosion. Never heat batteries in order to revive them. Do not disassemble
batteries. Remember to switch off devices after use. Keep batteries out of the reach of children, to avoid risk of ingestion, suffocation,
or poisoning. Utilize used batteries as prescribed by your country's laws.
Levenhuk International Lifetime Warranty
All Levenhuk telescopes, microscopes, binoculars, and other optical products, except for their accessories, carry a lifetime warranty
against defects in materials and workmanship. A lifetime warranty is a guarantee on the lifetime of the product on the market. All
Levenhuk accessories are warranted to be free of defects in materials and workmanship for six months from the purchase date. The
warranty entitles you to the free repair or replacement of the Levenhuk product in any country where a Levenhuk office is located if
all the warranty conditions are met.
For further details, please visit: www.levenhuk.com/warranty
If warranty problems arise, or if you need assistance in using your product, contact the local Levenhuk branch.
Figure 7
Levenhuk LC900
5–900m
meters/yards
class I, 905nm
1pc CR2 battery (3V, 900mA.h)
–10...+40°C (+14...+104°F)
–10...+50°C (+14...+122°F)
5
Levenhuk LC1500
5–1500m
6x
25mm
IP54