Compac CC15P Bedienungsanleitung Seite 2

Instruction Manual (GB)
Workshop crane, CC15P
Important: Read and understand this manual before use!
Instruction / Responsibility:
It is very important that the owner and the operator completely understand the operating manual
and all it's safety warnings before operating the workshop crane. It is important that the user has
comprehended all instructions before use. The manufacturer of the crane is not liable for damages
caused to people or things due to wrong- or irresponsible use of the crane.
Mounting:
Open the packages and check that the product has no damages caused by transportation and that
all parts are enclosed. Before operating the crane replace the oil plug (A) with the oil plug (B) with
hole for bleeding (fig. 1). The oil plug (A) is for transport ONLY!
Operating instruction:
The crane is operated by activating the pump lever. (fig.2) The arm is lowered again by turning the
release handle slowly counter-clockwise. (fig.3) The release-handle is spring-loaded due to safety
reasons. Test the crane first time by lifting without any load (fig.2) then place the telescopic arm
into the correct position according to the rated load (fig. 4) and test the crane with a load
WARNING the max. lifting capacities for the different positions of the arm
WARNING Safety instructions:
Do not overload the crane! Overload could result in damage to the crane or in worst case cause
accidents! Before lifting / transporting a load the operator MUST take precautions that the load is
not allowed to drop, and that the weight distribution is safe. The operator must before use take
precautions that all pins are safely locked with split pins or lock rings.
This workshop crane is to be used at level and solid ground only. (fig. 5).
Always lower the load to the lowest possible position before transportation.
Important! The safety valve is calibrated and sealed by the manufacturer and it is ABSOLUTELY
PROHIBITED! To open the seal or adjust it's calibration. Offence against the above safety
instructions could in worst case result in loss of the load which could cause personal injury and/or
damage to the crane or properties. In case the crane has any irregularities which could affect the
safety, the crane must not be operated until it has been repaired.
Maintenance:
At normal use all mechanical/moving parts only requires a monthly lubrication to be maintained.
The pins must be greased every three months. Important! Use only oil or grease free from acid.
An annual inspection must be performed by a skilled person. Every eventually wearing out or
defective part must be replaced with original spare parts. The owner and- or user must take
precautions that repair is made by a skilled person. Before every use the operator must take
precautions that there are no visible faults such as leaks, damage of the crane and loose or
missing parts.
In case the operator suspects that the crane has been overloaded or wrongly loaded it must before
further use be inspected by a skilled person or an authorized workshop.
Oil quantity: 1.5 liter. DO NOT use brake fluid or motor oil !
In case the hydraulic unit has a lack of oil or has been taken apart in order to replace the seals then
fill up to the correct oil quantity. Activate the pump handle and add oil slowly through the filling hole
2