Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Safety
This appliance should only be connected by a registered installer!
The electrical connection must comply with national and local regulations.
The wall plug socket and plug should always be accessible.
If the power cord is damaged, it should be replaced by the manufacturer or an authorised service
technician, in order to avoid hazard.
If you want to make a fixed connection, make sure that a omnipolar switch with a contact
separation of at least 3 mm is fitted in the supply cable.
If a stationary appliance is not fitted with a supply cord and a plug, or with other means for
disconnection from the supply mains having a contact separation in all poles that provide full
disconnection under overvoltage category III conditions, the instructions shall state that means
for disconnection must be incorporated in the fixed wiring in accordance with the wiring rules.
WARNING: Never open the appliance casing. The casing may only be opened by a service
technician.
Prior to connecting the drawer, ensure that all cables in your home's electrical system are of
sufficient diameter to supply the appliance properly.
Complete all electrical connections before building in the appliance.
Improper installation and maintenance work or repairs are dangerous. These may only be
performed by authorized and trained technicians. If the appliance has a defect, please disconnect
it and contact customer service.
If the appliance is mounted behind a furniture front (e.g. a door), never close it while the appliance
is in use. Heat and humidity accumulate behind a closed furniture front. This may damage drawer,
cupboard and floor.
Only use original replacement parts. These meet the required safety specifications.
Please note that the appliance must not be mounted tilted or upended. The design of the
appliance includes an oil-containing pump. Please refer to the installation instructions.
The manufacturer cannot be held liable for any damage resulting from failure to follow the safety
instructions and warnings.
Electrical connection
This appliance is manufactured in Class I; this means the device must be grounded.
For AU/NZS: Means providing full disconnection under overvoltage category III conditions must
be incorporated in the fixed wiring in accordance with AS/NZS 3000.
Check whether the power of the electrical mains corresponds to the power on the identification
plate on the appliance.
Before connecting to the electrical mains, check whether the power socket is grounded.
The device is equipped with a plug. When installing the appliance, remember that this plug must
remain accessible.
This warming drawer is designed for use by individuals in their home. It is only intended for
pre-warming tableware, keeping food warm and slow cooking. Any other use is prohibited and may
be dangerous. The manufacturer disclaims liability in the event of improper use.
Under certain conditions, the outside of the warming drawer may reach 70 °C (depending on the
selected temperature and length of use). Always use oven mitts or gloves to remove the warmed
tableware from the drawer.
Installation
9
Werbung
